Just got a Nuvi 30 and was able to download the training center, whenever I run the install for both mapsource 6.13.7 and 6.15.7 I always get "previous mapsource not found" I was able to download the 1.07 roadmap, I'm I doing something wrong? thanks in advance!!
-
-
install training center first then mapsource.Originally posted by Bobbysb View Post -
thank you for your reply Pokz! yes I have installed the training center and was running before I downloaded both mapsource, but still get that message, should my unit be connected? thanks again!!Comment
-
Bobbyb,
Please try this:
http://roadguide.ph/forums/showthread.php?t=4345
Just to clarify the steps for regular install are:
1. Install Training center.
2. Install Mapsource
3. Install Map 1.07 then Demo 2.01
The link above allows to skip training center install.
TTFN
ArvinLast edited by arvin555; 10-08-2011, 12:27.Comment
-
Will uninstall everything and start again, thanks ArvinComment
-
Don't thank us yet, you haven't succeeded
Good luck though!
TTFN
ArvinComment
-
Hmmm still can't get mapsource running....
Step by step
1. download traning center /ok
2. download both 6.13.7 and 6.15. /both ok
3. download roadmap 1.07 basic map /ok
4. install and run training center / ok, I can see the roadmap 1.07 on the map
5. when I run both mapsource version it will uinzip and when you get to accept terms and condition it gives error previous mapsource not foundComment
-
Babby,1. download traning center /ok
2. download both 6.13.7 and 6.15. /both ok
3. download roadmap 1.07 basic map /ok
4. install and run training center / ok, I can see the roadmap 1.07 on the map
5. when I run both mapsource version it will uinzip and when you get to accept terms and condition it gives error previous mapsource not found
There are a few steps that you might not have listed on the above steps you mentioned. For instance, you mentioned downloading only, but then suddenly on step 4 you already said "I can see roadmap 1.07 on the map" what map? You did not even start installation yet right?
Okay please delete everything again and do this:
1. Uninstall everything again!
2. Download and then Install Training center (you don't have to redownload of course, just run training center first)
3. Install Mapsource 6.15.7 only do not do a multiple version install.
4. Run the install for RG Map 1.07
5. Open Mapsource
Install the map only after you installed Mapsource.
Also because you have already mulitple installs, I am almost sure that your Registry already has a lot of junk, the problem is that messing with your registry is a bit dangerous for your OS.
Finally please try to use this instead:
http://roadguide.ph/forums/showthread.php?t=4345
TTFN
ArvinComment
Comment